Skip to main content
6:10

Playing this video loads it from YouTube, which will receive your IP address.

Using the kill switches in the mix on the KAM KCM 450 MK 2

Lesson Intermediate Stage 4: Mixing & Transitions November 2008

Contents of the video

All right folks, in this video I'm going to do two mixes. The first mix I'm going to just basically go from one side through to the other just by using the crossfade. I'm not going to touch the bass, mid, treble, anything. I'm going to do near enough exactly the same mix but the difference being I'm going to do as with the first one, go across, but I'm going to be using the actual kill switches. So what I'm going to do, I'm going to pause the camera and I'm going to actually plug He also covers bass, mid and treble. He also covers bass, mid and treble. You can make it higher or lower, treble, mid or bass. The difference with the actual kill switches, you can't necessarily tweak them. What you can do though is get rid of with one fell swoop. With this particular mixer if you move the kill switches down then if you keep your finger on them they will stay off. As soon as you take your finger off they'll flick back to the centre position which means you get those frequencies

Thank you very much.

This transcript was produced automatically from the audio of the video and may contain mistakes.

The stages are the way through

Below this line is the back catalogue, newest first. Useful for browsing, but it is not a course - the videos are in the order they were filmed, not the order to learn them in. Work the stages instead: each one assumes the one before it.

Latest DJ Tutor Videos